ADC 400F User Manual
Page 51
Chapter 6: Configuring Sessions
Megabit Modem 400F User Manual
43
5
Click
Submit
to accept the LAN configuration.
6
After entering a LAN IP address and subnet mask (or changing the IP address and subnet
mask), effect the configuration completing the procedures for
.
For
Routing
mode, select the direction you want RIP activated and the version
of RIP for intergateway transmissions. See “Routing” on page 66 for more
information on RIP. RIP is a dynamic routing protocol.
Enter the
IP Address
and
IP Net Mask
for the modem’s Ethernet 10/100BASE-T
LAN port.
Enter the
Default gateway IP address
and
Default gateway Net Mask
for the modem to
access other LAN segments or IP addresses not in its routing table.
Select
DHCP Enable
to enable the modem to act as a DHCP server to automatically
assign IP addresses to devices on the LAN. If you select DHCP, ensure that all
devices on the LAN have the TCP/IP stack set to
obtain an IP address automatically
(see
“Setting Up the PC to Request an IP Address” on page 59
). (Only in routing
mode)
The modem automatically enters the start IP address for the first device on the LAN
as one address higher than the Ethernet port on the modem with DHCP enabled.
You cannot edit this field.
Enter an IP address for a device that will provide
Primary DNS
. DNS translates
human-readable machine names into IP addresses.
Enter an IP address for a device that will provide
Secondary DNS
. DNS translates
human-readable machine names into IP addresses (optional).
The modem automatically enter the
Gateway
IP address which is the same
IP address as the Ethernet 10/100BASE-T port of the modem. You cannot edit
this field.
Click
Static MAC Table
to get a dialog to set up static MAC addresses for the modem.
The modem will learn up to 1024 MAC addresses and accept up to 32 MAC static
entries. Go to
“Defining or Modifying Static MAC Entries” on page 44
to
configure these parameters.
Click
Static Route Table
to get a dialog to set up static Routing IP addresses for the
modem to recognize. The modem can accept up to 32 static route entries. Go to
“Defining Static Route Entries” on page 45
to configure these parameters.