Installing the modem, Nstalling the, Odem – ADC 400F User Manual
Page 19
Megabit Modem 400F User Manual
11
3
I
NSTALLING THE
M
ODEM
The Megabit Modem 400F is easy to install:
•
attaching adhesive-backed feet
•
setting the MDI/MDI-X switch
•
connecting a cable from the modem to a PC or an Ethernet hub for LAN service
•
connecting a phone cord from the modem to a wall phone jack for DMT ADSL Internet
or other types of WAN services
•
connecting a power cable to a local power outlet
Perform the installation on the following pages (see
“Location for Modem Installation” on
to determine where to place modems). Use the parts listed below in the installation
procedures.
Part
Function
Installation Kit
Rubber feet (four)
Attaches to the base of the modem.
Black cable
Connects the modem 10/100BASE-T connector to the LAN through a hub
or to a PC NIC.
Grey phone cord
Connects the modem ADSL connector to the RJ-11 wall jack with DMT
ADSL service for access to the Internet or other types of WAN applcations.
Power cable
Connects the modem POWER connector to the local power source. Power
supply optionally has a power cord. (See
for
selection options.)
Not In Installation Kit (in ship box)
Grey cable and
adapter
Connects the RS-232 MGMT port to an ASCII terminal or a PC running
terminal emulation software. Adapter assembly connects to a DB-9
connector on the PC. Then, one RJ-45 connector installs in the adapter and
the other connector into the console port on the modem.