PERKO 1072 - Manual

Figs. 1071/1072 Series
Figs. 1081/1082 Series
FO
LD
O
VE
R
ED
G
E
O
F
DO
O
R
1-5/8” Drill 2-3/8 Inch hole
Cat No. 1071/1072 #1 Series Lock with Flush Cam Bar and Flexible Plastic Strike Plate.
Cat No. 1071/1072 #2 Series Lock with Offset Adjustable Cam Bar.
Cat No. 1071/1072 #3 Series Lock with Straight Cam Bar and Flexible Plastic Strike Plate.
Cat No. 1081/1082 #1 Series Latch with Flush Cam Bar and Flexible Plastic Strike Plate.
Cat No. 1081/1082 #2 Series Latch with Offset Adjustable Cam Bar.
Cat No. 1081/1082 #3 Series Latch with Straight Cam Bar and Flexible Plastic Strike Plate.
Note: Figs. 1071/1072 Series for use on carpeted surfaces only.
Figs. 1081/1082 Series for use on smooth or carpeted surfaces.
MOUNTING INSTRUCTIONS
These locks or latches are designed to be mounted through surfaces from 1/8 inch to 7/8 inch thick. The
cam bars are adjustable to a maximum of 3 inches from the mounting surface. (The optional strike plate is
supplied only with style #1 & #3).
1). Cut out the template below. Fold on dotted line. Place on mounting surface at desired location with
folded tab overlapping edge.
2). Mark center of hole for drilling.
3). Drill a 2-3/8 inch hole through the mounting surface.
4). Reverse spacer if necessary on very thin surfaces. Use mounting gasket for smooth surfaces
(supplied with Fig. 1081/1082 series only) or discard for carpeted surfaces.
5). Insert lock or latch through the hole in the surface and attach spacer and back-up nut.
6). Mount strike plate (if desired) on suitable surface.
7). Re-assemble cam bar with proper adjustment. Tighten set screw and locking nut with lock washer.
Note: For continued ease of operation, periodically apply a lock cylinder lubricant.
MOUNTING TEMPLATE
PERKO, Inc.
16490 N.W. 13th Avenue
Miami, FL 33169-5707
www.perko.com
(SEE OVER)
6/02
1071INS1