PERKO 1030 User Manual
PERKO Hardware
Fig. No. 0928 Series Regular Bevel with Box Strike
Fig. No. 0930 Series Reverse Bevel with Flush Strike
Fig. No. 1028 Series Reverse Bevel with Box Strike
Fig. No. 1030 Series Regular Bevel with Flush Strike
MOUNTING INSTRUCTIONS
These Rim Latch Sets are designed to be mounted on the surface of doors 5/8 inch to 1-3/8 inches thick.
1).
Cut out the template below. Fold on the dotted line. Place on door at desired height on the side to
have the rim latch. Folded tab should overlap edge.
2).
Mark center of circle for drilling.
3).
Drill 9/16 inch hole through center.
4).
Inset lever handle with shaft through the rim latch. Put shaft through the hole drilled in step #3 above,
align and fasten rim latch to door with #6 screws (Not Supplied). Place escutcheon plate over the
shaft on opposite side of door. Align and fasten with #6 screws (Not Supplied). Thread the knob on
shaft and tighten set screw on knob.
5).
Mount strike on door frame.
PERKO, Inc.
16490 N.W. 13th Avenue
Miami, FL 33169
www.perko.com
MOUNTING TEMPLATE
10/04
CAT. NOS.
0928000CHR
0928DP0CHR
0930000CHR
0930DP0CHR
1028000CHR
1028DP0CHR
1030000CHR
1030DP0CHR
9/16” HOLE
1-3/8”
FOLD OVER EDGE OF DOOR
(SEE OVER)