Agilent Technologies N5700 - Manual (Page 15)

SCPI Programming Commands – At a Glance.
Series N5700 User’s Guide 15
SCPI Programming Commands – At a Glance
.
NOTE
Some [optional] commands have been included for clarity. Chapter 6 contains a
complete description of all programming commands.
Subsystem Commands.
SCPI Command Description
ABORt Aborts the triggered action
CALibrate
:CURRent[:LEVel]
Calibrates the output current programming
:DATA Enters the calibration value
:DATE “” Sets the calibration date
:LEVel P1 | P2 Advances to the next calibration step
:PASSword Sets the numeric calibration password
:STATE [,] Enables/disables calibration mode
:VOLTage[:LEVel] Calibrates the output voltage programming
INITiate
[:IMMediate][:TRANsient]
Initiates the trigger system
:CONTinuous[:TRANsient] Enables/disables continuous triggers
MEASure
[:SCALar]
:CURRent[:DC]? Returns the measured output current
:VOLTage[:DC]? Returns the measured output voltage
OUTPut
[:STATe]
Enables/disables the specified output
:PON
:STATe RST | AUTO Programs the Power-On State
:PROTection
:CLEar Resets latched protection
[SOURce:]
CURRent
[:LEVel]
[:IMMediate][:AMPLitude] Sets the output current
:TRIGgered[:AMPLitude] Sets the triggered output current
:PROTection
:STATe Enables/disables over-current protection
VOLTage
[:LEVel]
[:IMMediate][:AMPLitude] Sets the output voltage
:TRIGgered[:AMPLitude] Sets the triggered output voltage
:LIMit
:LOW Sets the low-voltage limit
:PROTection
[:LEVel] Sets the over-voltage protection level