PASCO PS-2010 AirLink2 - Manual

®
I n s tr u c t i o n M a n u a l
0 1 2 -1 1 1 1 4 C
PASPORT AirLink
2
PS-2010
*012-11114*
Equipment and Software
Introduction
The PASPORT AirLink
2
is a sensor interface for PASPORT
sensors that wirelessly connects to iPad™, iPhone® and
iPod touch® devices and Macintosh® and Windows® com-
puters through Bluetooth™. The AirLink
2
uses a rechargeable
lithium polymer (Li-Poly) battery (installed) and comes with a
USB cable that allows the battery to be recharged while the
AirLink
2
is connected to a computer’s USB port or a USB
power supply.
About the Manual
Part One of this manual describes how to use the AirLink
2
with the iPad, iPhone or iPod touch, including how to down-
load and run the SPARKvue application on the iPad, iPhone or
iPod touch. Part Two describes how to use the AirLink
2
sensor
interface with a computer and the PASCO DataStudio pro-
gram.
Bluetooth Requirements
The iPad, iPhone and iPod touch are Bluetooth compatible.
Consult your computer’s documentation to determine if it is
Bluetooth-capable. Your Macintosh computer must be running
Mac OS X 10.2.1 or higher and your Windows computer must
be running Windows XP with Service Pack 2 (SP2) or higher.
1
If your computer is not already Bluetooth capable, you may
be able to add Bluetooth capability by purchasing a Bluetooth
module that connects to a computer’s USB port (such as the
PASCO PS-2553 Bluetooth USB Adapter). When setting up a
Windows computer with Bluetooth, it’s best to try the default
ON/OFF Switch
Lanyard Loop
Green LED
Yellow LED
Red LED
USB Port
(not shown)
Included Part Number
PASCO AirLink
2
Sensor Interface PS-2010
USB Cable* for GLX or SPARK
Science Learning System
PS-2528
* not shown
Also Required
PASPORT Sensor see catalog or web site
and
iPad or iPhone 3G or iPhone 3GS or
iPod touch (2nd or 3rd generation)
see www.apple.com
SPARKvue app see www.itunes.com/apps/
or
DataStudio Software (1.9.8r9 or later) see catalog or web site
Bluetooth compatible computer
1