PASCO ME-6569 RMS_IDS KIT User Manual
Page 16

RMS/IDS Kit
012–06408A
12
Procedure
Part A Inelastic collision of equal masses
Set Up the Equipment
1.
Mount the two Rotary Motion Sensors on the IDS track using the IDS Mount Accessories,
and mount the two brackets with small pulley on the IDS track (refer to the page 2 of this
manual and Figure 3.1).
In contrast to the case with momentum, KE is not conserved after the collision:
2.
Attach the cartstring brackets to the carts, measure the mass of the carts, and record in
Table 3.1.
3.
Place the carts on the track with the Velcro tabs (Plunger Cart) or nonmagnetic ends (Collision
Cart) facing each other.
4.
Thread the string as shown in Figure 3.1 and pages 2 & 3 of the manual. Make the necessary
adjustments to the setup to insure that the string is unobstructed and moves freely.
5. Adjust the brackets with small pulley as necessary to insure that the thread is taunt and not
slipping on the pulleys.
Set Up Science Workshop
1.
Insert the digital plugs for the RMS connected to cart 1 into digital channels 1 & 2, and the
digital plugs of the RMS connected to cart 2 into digital channels 3 & 4 of the interface
box.
Figure 3.1
Equipment setup for experiment 3
RMS
magnetic ends
(Collision Carts)
cart—string brackets
IDS track pulley brackets
IDS track
IDS Mount
Accessory
thread
1
2
m
1
v
1
2
+
1
2
m
2
v
2
2
≠
1
2
m
after
v
after
2
cart 1
cart 2
Velcro tabs
(Plunger Carts)