Pach and Company Quantum QC Series Manual - Manual (Page 35)

Table of Contents
file:///C|/PACH%20&%20COMPANY/PACH-CO.COM/PACH-CO.COM%202012/online_manual/qc_series_manual.htm[5/19/2014 9:40:29 AM]
3. Enter relay 1 (door 1) then press #
then press #
or relay 2 (door 2) then press #,
then press #
Function Code 46 Firmware Version
To check the system's firmware version
1. Log-in to programming
2. Enter 46 then #
Function Code 48 PBX Enable
If the system is installed behind a Private Branch Exchange (PBX) then 9 is necessary before dialing an outside line. If
this function is enabled then the system can only be dialing an outside line, it cannot dial the extension.
1. Log-in to programming
2. Enter 48 then #
3. Enter 0= disable or 1= enable then press #
4. Enter the number to access dial tone to dial an outside line, generally 9 is the default number for most PBX system,
then press #
5. Select delay time for the PBX system to access dial tone, generally 2-3 second delay is plenty of time, then press #