Pach and Company AeGIS 4000RTP Quick Guide User Manual
Warning
PACH AND CO 1‐888‐678‐7224 Quick Reference
Download Complete Installation and Programming Manual at
www.pach‐co.com
Missing Parts, contact Pach and Company 1-888-678-7224
Defective system under manufacturer warranty,
CALL 1-888-678-7224 for advance replacement
24 Months warranty
for complete system, does not include
installation labor
6 Months warranty
for Printed Circuit Board, does not include
installation labor
PROGRAMMING FUNCTION CODES TABLE
Exit program, hold for 1 second
to hang-up call
76
Delete phone number on 70,
71 and 72
Save program or initiate
program
87
Disable or enable automatic
call forwarding. 0= disable
(default), 1= enable
00
Change master code (0000 is
default)
88
Select automatic call
forwarding 71 or 72
01-20
Add individual access code for
relay 1
89
Select automatic call
forwarding time 15-90
seconds. Default= 15
seconds.
21-40
Add individual access code for
relay 2
90
Manually close or open relay
1. 1= open, 0= close
41-50
Add individual access code for
relay 1 & relay 2
91
Manually close or open relay
2. 1= open, 0= close
51
Relay 1 open time interval (01-
90 seconds) default 12
seconds
92
Talk time 10-90 seconds.
Default= 60 seconds
52
Relay 2 open time interval (01-
90 seconds) default 12
seconds
93
Lock-out count 03-09.
Default= 03
60
Delete all access codes 01-20
94
Auxiliary input (enable radio
receiver)
0= disable
1= enable control by door
open interval function code
51.
2= enable control by auxiliary
input.
61
Delete all access codes 21-40
95
Alarm Mode
1= enable
0= disable
Default= 10 seconds local
alarm.
Default= 30 seconds remote
62
Delete all access codes 41-50
96
System answer mode
0= disable, default
1-9= enable 1- 9 rings, when
enable no call waiting feature.
65
Delete all access codes
97
Do not disturb mode
0= disable, default
1= enable
70
Direct call forwarding, phone
number up to 11-digit.
98
Select initiating premise call
key
0= *
1= #, default
71-72
Automatic or manual call
forwarding, phone number up
to 11-digit
99
Set memory to factory default,
then press 1# to confirm.
WARNING:
DO NOT USE ON BOARD 12VDC and GND
TO POWER A DOOR STRIKE OR MAGNETIC LOCK
SEPARATE POWER MUST BE USED TO POWER A DOOR
STRIKE OR MAGNETIC LOCK.