Control Company 5026 QC TIMER User Manual

Control company

SPECIFICATIONS
Display:

¾’’ LCD

Range:

Counts down from 20 hrs.

Resolution:

1 min.

Accuracy:

0.01%

Case:

ABS plastic

Power:

One 3-year AAA battery

Accessories Supplied:

3-year AAA battery, magnet/clip, Traceable

certificate, instructions

QC Timer Operation
1.

Turn the timer on by inserting the battery. To insert the battery, slide the battery cover located on the back of the unit away from the unit. Place the supplied
battery inside. Replace the battery cover.

To set the desired time, press the HR and MIN buttons. Each press advances the time 1 hour or 1 minute, respectively. To rapidly advance the time, press and
hold the buttons.

Press the START/STOP button once to begin counting down. The blinking colon (:) indicates the time is running.

To temporarily stop the countdown time, press the START/STOP button once. To resume countdown, press the START/STOP button again.

When the timer reaches zero, an alarm will sound for 1 minute. Press the ALARM STOP button to silence the sounding alarm.

When the timer is counting down, clear the display by pressing the START/STOP button to stop the countdown. Then press the CLEAR button. If the timer is
not counting down, press the START/STOP button twice and then press CLEAR.

Battery Information
Please replace the battery in the case of any operational difficulties or lack of proper functionality for any reason. Slide the battery cover located on the back of the
unit away from the unit. Remove the old battery and replace it with a new AAA battery. Replace the battery cover. Incorrectly installed batteries may damage
electronics.

Replacing the battery with a new fresh battery will solve most difficulties.

Warranty, Service, or Recalibration
For warranty, service, or recalibration, contact:

CONTROL COMPANY

4455 Rex Road

Friendswood, Texas 77546 USA

Ph. 281-482-1714 Fax 281-482-9448

E-mail [email protected]

www.control3.com

Control Company is ISO 9001 Quality-Certified by DNV and ISO 17025 accredited as a Calibration

Laboratory by A2LA.

Control Company Cat. No. 5026. Rev 1 040808
Traceable

is a registered trademark of Control Company

TRACEABLE

QC TIMER INSTRUCTIONS