Control Company 1034 DUAL-DISPLAY DIGITAL STOPWATCH - Manual (Page 2)

● With each press of “C”, the time stored is recalled. The time can be recalled
successively be keeping the button pressed.
● To stop the recall of the stored data, press “A”, “B” or “D”. The measurements
when the stopwatch was stopped will be shown. Then press “B” to reset the
digits to “00”.
● The time stored in the memory can be recalled even while the stopwatch is
measuring.
WITH EACH PRESS OF “C”
When the stopwatch is stopped
Fastest Lap, Slowest Lap, after that.
Split time and lap time are recalled starting with
the first ones.
When the stopwatch is running Fastest Lap, Slowest Lap, after that, Split time
and lap time are recalled starting with the last
ones.
Notes:
1.
To measure the lap time and split time while the stored data is recalled, operate
the buttons as follows. Press “B” to measure new lap time and split time. Press
“A” to stop or start the measurement.
2. When the memory is full, “split / lap number” flash, extra split / lap times will not
store into memory but the memory counter will still show extra split/lap times.
The fastest, slowest and average laps will not store into the memory.
Warranty, Service, or Recalibration
For warranty, service, or recalibration, contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281-482-1714
Fax 281-482-9448
E-mail [email protected]
www.control3.com
Control Company is ISO 9001 Quality-Certified by
DNV and ISO 17025 accredited as a Calibration
Laboratory by A2LA.
Control Company Cat. No. 92-1034-00 Rev. 0 051508
Traceable
® is a registered trademark of Control Company
© 2008 Control Company