Control Company 1042 WATER/SHOCK RESISTANT STOPWATCH - Manual (Page 2)

All Operational Difficulties
If this stopwatch does not function properly for any reason, please replace battery with a
fresh high-quality battery (see BATTERY REPLACEMENT section). Low battery power
can occasionally cause any number of “apparent” operational difficulties. Replacing
battery with a fresh battery will solve most difficulties.
Battery Replacement
An incorrect display, no display, or operational difficulties indicate that battery should be
replaced. To replace battery: remove six screws on back of unit. Loosen screw on
BATTERY CLIP so clip can slide to gain access to battery. Removed depleted battery.
Install fresh battery in appropriate position so that + side of battery is visible. Replace
BATTERY CLIP. Replace back of unit. Replace six screws and tighten securely.
Replacement battery Cat. No. 1039.
Warranty, Service, or Recalibration
For warranty, service, or recalibration, contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281-482-1714
Fax 281-482-9448
E-mail [email protected]
www.control3.com
Control Company is ISO 9001 Quality-Certified by
DNV and ISO 17025 accredited as a Calibration
Laboratory by A2LA.
Control Company Cat. No. 92-1042-00/92-1045-00 Rev. 5 051608
Traceable
® is a registered trademark of Control Company
© 2008 Control Company