beautypg.com

Control Company 5013 FLASHING LED ALERT BIG-DIGIT ALARM TIMER User Manual

Page 2

background image

StopwatcH (coUnt-Up) tiMinG

1. Clear the display to zero.

2. Press the S/S button to begin count-up timing.

3. Press the S/S button to stop count-up timing.
Once timing is complete and the timer has

been stopped, press the MIN and SEC buttons

simultaneously to clear the display to zero.

tiMeoUt

The timer may be stopped during any running time

(countdown or count-up) by pressing the S/S button.

Timing may be resumed by pressing the S/S button a

second time.

conVeRt a tiMeoUt to a coUntDown tiMe

The timer may be stopped during any running time

(countdown or count-up) by pressing the S/S button.

Once the timing has been stopped, pressing the MIN

or SEC button will increment the display from the

point that it was stopped and will set the timer into

countdown mode. Once the desired time is on the

display, press the S/S button to begin countdown

timing.

aLL opeRationaL DifficULtieS

If this timer does not function properly for any reason,

replace the batteries with new high quality batteries

(see the “Battery Replacement” section). Low battery

power can occasionally cause any number of “appar-

ent” operational difficulties. Replacing the batteries

with new fresh batteries will solve most difficulties.

BatteRY RepLaceMent

An incorrect display, no display or operational difficulties

indicate that the batteries should be replaced. Slide

open the battery cover on the back of the timer. Insert

two (2) new AAA alkaline batteries. Make certain to

note the proper polarity as indicated by the diagram in

the battery compartment. Replace the battery cover.

waRRantY, SeRVice, oR caLiBRation

For warranty, service, or calibration contact:

Control Company

4455 Rex Road

Friendswood, Texas 77546 USA

Ph. 281 482-1714 • Fax 281 482-9448

www.control3.com • [email protected]

Control Company is ISO 9001 Quality-Certified by DNV and

ISO 17025 accredited as a Calibration Laboratory by A2LA

Control Company Cat. No. 5013

Traceable

®

is a registered trademark of

Control Company.

©

2010

Control Company.

92-5013-00 Rev. 1 093010

traCEaBlE

FlaSHInG

lED alErt

BIG-DIGIt

alarm tImEr

InStrUCtIonS

®