Control Company 5017 FLASHING LED ALERT BIG-DIGIT DUAL CHANNEL ALARM TIMER - Manual (Page 2)

While a channel is alarming, once the channel is
selected by pressing the T1 / T2 button, pressing
the S/S button will stop the alarm, stop the count-up
timing, and recall the programmed countdown time.
After one minute, pressing the S/S button for the
selected channel will stop the count-up timing. To
recall the programmed time, press the M button.
Both timing channels may be used simultaneously.
cLeaRinG coUntDown MeMoRY
1. Select the desired channel by pressing the T1 / T2
button.
2. Clear the display to zero.
3. Press and hold the M (memory) button for three (3)
seconds (the display will flash zero).
4. With the display flashing zero, press the M
(memory) button to confirm the entry (the display
will no longer flash).
StopwatcH (coUnt-Up) tiMinG
1. Select the desired channel by pressing the T1 / T2
button.
2. Clear the display to zero.
3. Press the S/S button to begin count-up timing.
4. Press the S/S button to stop count-up timing.
Once timing is complete and the timer has
been stopped, press the HR and MIN buttons
simultaneously to clear the display to zero.
Both timing channels may be used simultaneously for
countdown or count-up timing.
tiMeoUt
A timing channel may be stopped during any running
time (countdown or count-up) by selecting the channel
and pressing the S/S button. Timing may be resumed
by pressing the S/S button a second time.
conVeRt a tiMeoUt to a coUntDown tiMe
A timing channel may be stopped during any running
time (countdown or count-up) by selecting the channel
and pressing the S/S button. Once the timing has
been stopped, pressing the HR, MIN and SEC buttons
will increment the display from the point that it was
stopped and will set the timer into countdown mode.
Once the desired time is on the display, press the S/S
button to begin countdown timing.
aLL opeRationaL DifficULtieS
If this timer does not function properly for any reason,
replace the batteries with new high quality batteries
(see the “Battery Replacement” section). Low
battery power can occasionally cause any number
of “apparent” operational difficulties. Replacing the
batteries with new fresh batteries will solve most
difficulties.
BatteRY RepLaceMent
An incorrect display, no display or operational difficulties
indicate that the batteries should be replaced. Slide
open the battery cover on the back of the timer. Insert
two (2) new AAA alkaline batteries. Make certain to
note the proper polarity as indicated by the diagram in
the battery compartment. Replace the battery cover.
waRRantY, SeRVice, oR caLiBRation
For warranty, service, or calibration contact:
Control Company
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281 482-1714 • Fax 281 482-9448
www.control3.com • [email protected]
Control Company is ISO 9001 Quality-Certified by DNV and
ISO 17025 accredited as a Calibration Laboratory by A2LA
Control Company Cat. No. 5017
Traceable ® is a registered trademark of Control Company.
© 2010 Control Company. 92-5017-00 Rev. 1 093010
traCEaBlE
FlaSHInG
lED alErt
BIG-DIGIt
DUal CHannEl
alarm tImEr
InStrUCtIonS
®