Nova-Tech PW Series - Manual (Page 8)

Page 8 of 48
© Adam Equipment Company 2007
5.0 SETTING UP THE BALANCE
5.1 ASSEMBLING THE BALANCE
• Locate balance on solid surface, free from vibration
• Open the sliding door and gently place the square base plate, the
locating disc, weighing platform, the guard ring and then the stainless
steel top.
• Level balance using the adjustable feet and spirit level
• Connect the power to the balance
• For best performance, let the balance warm up for 30-60 min. and
calibrate before using
5.2 LEVELLING THE BALANCE
After placing the balance in a suitable place,
level it by using the spirit level. To level the
balance turn the two adjustable feet at the rear
of the balance until the bubble in the spirit level
is centred.
5.3 WARM-UP TIME
Attach the power supply cable to the connector
on the rear of the balance. Plug the power
supply module into the mains. The display will
indicate the balance serial number (if set) and
the software revision number followed by the
capacity of the balance. Next the balance will
run a self-test by displaying all segments
followed by a symbol indicating the balance is in
busy mode. If the balance serial number is not
set the display will show dashes. The display
will show zeroes accompanied by the
0
symbol. If the balance is not used for a long
time, it will go back to the auto-calibration mode.