Nova-Tech PW Series - Manual (Page 20)

Page 20 of 48
© Adam Equipment Company 2007
• Press [Up] or [Down] to select “rUN” for starting the animal / dynamic
weighing using the method previously set or “SEtUP” to set up the
balance for animal weighing (see the section 9.4.4.1
Animal Weighing
Setup Parameters)
MANUAL MODE
When the balance is in the MANUAL mode –
If
[Enter] is pressed when “rUN” is selected, balance will display “START ?”
Place the item on the pan and press
[Enter] again
The result will be displayed by showing “FINISHED xx.xx x” after a pre-set
time Delay and Sampling period (see the section 9.4.4.1
Animal Weighing
Setup Parameters)
AUTO MODE
When the balance is in the AUTO mode –
If
[Enter] is pressed when “rUN” is selected, balance will display “LOAD PAN”
Place the item on the pan. The animal weighing test will begin automatically
After the configured Delay and test time are computed by the balance, the
result will be shown displaying “FINISHED xx.xx x” (see the section 9.4.4.1 on
Animal Weighing Set-Up Parameters)
• During animal weighing if the [Print] key is pressed, the balance will
display “PAUSED” and show the current average
• To resume, press [Print] again or
• Pressing [Mode] will display “STOPPED” and terminate the weighing
• Remove the item from the pan
• Press [Mode] to go back to “ANIMAL rUN” to weigh another item or
[Esc] to return to normal weighing