Nova-Tech PW Series - Manual (Page 32)

Page 32 of 48
© Adam Equipment Company 2007
The parameters that can be set are:
ENABLE
The serial port can be set to On or OFF
BAUD RATE
Set the Baud Rate to 4800, 9600, 19200 or 38400, the
default rate being 4800
PARITY
Set the Parity to NONE, EVEN or ODD
STABLE To print when stable (On) or regardless of stability (OFF)
CONTINUOUS Set the RS-232 to send data continuously to On or OFF
PERIODIC Set the RS-232 to send data periodically (set in seconds)
to On or OFF. If On is selected, the value can be changed
between 1 and 999 seconds, using
[Up] and [Down]
FORMAT
To send data as a single line of data, using the standard
format or using a customer designed format (FORM 1 or
FORM 2).
Format of custom forms #1 and #2
If FORM1 or FORM2 is selected, it can be changed by the user using a
selection of available data. By default the 2 forms are the same as the
standard form unless changed by the user as below.
When FORM 1 or FORM 2 is selected the user can set the information to be
printed on each line of the form. Pressing the
[Up] or [Down] keys will cycle
through the options available. The options are:
INST ID Instrument ID number
SER No Serial Number
TIME Time
DATE Date
NET Net Weight (Gross weight – Tare Weight)
GROSS Gross Weight
TARE Tare Weight
UNIT Unit weight in parts counting mode
COUNT Number of items in parts counting mode
REF 100% weight in percent weighing mode
PERCENT Percentage of reference weight in percent weighing
LO LIMIT Low Limit when check weighing