Nova-Tech PW Series - Manual (Page 31)

Page 31 of 48
© Adam Equipment Company 2007
enable/disable weighing units or modes, set balance parameters for the
conditions, set time and date, set parameters for the RS-232 interface,
calibration parameters and security parameters
•
The display will show the first menu item “UNITS”. The [Up] and
[Down] keys will cycle through the main menu item, pressing [Enter]
key will enter the sub-menu or options can be set. Press
[Mode] to
come out of a sub-menu or [Esc] to return to normal weighing
13.1 ENABLE WEIGHING UNITS
• When “UNITS” is displayed, press [Enter]. The display will show the
symbol for the first unit, e.g. carats, ct, together with its enable state
“OFF” or “On”. The user can then enable or disable the carats unit by
using
[Up] or [Down]. Pressing [Enter] will confirm the setting and will
advance to the next weighing unit. Repeat for each weighing unit in
turn. Gram is always enabled
• Press [Mode] to advance to setting of the next menu or press [Esc] to
return to normal weighing
13.2 ENABLE WEIGHING MODES
Same steps are followed to enable or disable the weighing modes.
• Press [Enter] when “MODES” is displayed. The display will show the
first mode i.e., Parts Counting (“PARTS”) together with its enabled state
“OFF” or “On”. The user can enable or disable the parts counting mode
by using
[Up] or [Down]. Pressing [Enter] will confirm the setting and
will advance to the next weighing mode. Repeat for each mode in turn
• Press [Mode] to advance to setting of the next menu or press [Esc] to
return to normal weighing
13.3 ENABLE SERIAL INTERFACE PARAMETERS
The parameters affecting the serial setup are set in a similar manner to the
other parameters.
Press
[Enter] to enter the sub-menu.