Detroit Radiant Products Company LD3 Series - Manual (Page 5)

5
LD3 Series
SERVICE ACCESS PANEL
1.0 Introduction • Safety Signs and Labels
SERVICE ACCESS PANEL IGNITER & FLAME SENSE COMPARTMENT
1. Disconnect gas & electricity. 2. Remove cover by lifting top cover upward and outward. CAUTION: HOT SURFACE. KEEP COVER IN PLACE. REMOVE FOR SERVICE ONLY.
DETROIT RADIANT PRODUCTS COMPANY 21400 HOOVER ROAD - WARREN, MI 48089 (586) 756-0950 www.reverberray.com
LOW-INTENSITY INFRARED HEATER
MAX. HEAT INPUT MAX. DEBIT CALORIFIQUE
MIN. HEAT INPUT MIN. DEBIT CALORIFIQUE
VENT CATEGORY ÉVENT CATÉGORIE
BTU/h
BTU/h
VOLTAGE
AMPS
PHASE
FREQUENCY Hz
VAC MANIFOLD PRESSURE PRESSION A LA TUBULURE D'ALIMENTATION
MAXIMUM INLET PRESSURE PRESSION D'ALIMENTATION MAXIMALE
MINIMUM INLET PRESSURE FOR PURPOSE OF ADJ. PRESSION D'ALIMENTATION EN GAS MIN. ADMISE
INCHES W.C.
INCHES W.C.
INCHES W.C.
RADIATEUR À INFRAROUGE À FAIBLE INTENSITÉ
ORIFICE SIZE DIM DE L'INJECTEUR NATURAL GAS PROPANE GAS
THIS DESIGN COMPLIES WITH STANDARD(S): COMPLES DE CETTE CONCEPTION AVEC LA NORME:
HEATER BUILD TYPE
TYPE OF GAS TYPE DE GAZ
MIN. MOUNTING ANGLE MIN. ANGLE DE SUPPORT
MAX. MOUNTING ANGLE MAX. ANGLE DE SUPPORT
MODEL NUMBER NUMÉRO DE MODÈLE SERIAL NUMBER NUMÉRO DE SÉRIE VERSION
COMBUSTION CHAMBER
®
FOR COMMERCIAL / INDUSTRIAL USE. FOR INDOOR USE ONLY. MADE IN U.S.A.
40,000
25,000
CATEGORY III
2.4
SINGLE
60
120 3.5
14.0
5.0
49 D.M.S. 57 D.M.S.
ANSI Z83.20b-2011 • CSA2.34B-2011 RADIANT TUBE HEATER
C1
NATURAL
AGA 7-89 RESIDENTIAL RADIANT TUBE HEATER
0°
45°
LD3-20-40N YYMMREPCSHIPPE#### 09/12
TP-26B; INCH BC ALUMINIZED
Controls Compartment
Burner Control Box
Component Label
(located inside the center
compartment lid)
LD3-20-40N
Data on this label is for the model shown on this label. If your heater has been converted,
this information is not accurate. Please contact the factory for assistance.
BURNER COMPONENTS:
For parts replacement information, contact factory at 586-756-0950 or visit www.drp-co.com/parts.
Serial No.: 1311XXXXXXXXXX 0001
Gas Valve:
Circuit Board:
Wire Harness:
N.O. Switch:
N.O. VL Orifice:
N.C. Switch:
N.C. VL Orifice:
Diff Switch:
Diff VL Orifice:
Igniter:
Burner:
16” Tube:
Ind. Lights: Diag. Light:
Term. Block:
Transformer:
Fan:
Alt. Fan:
Alt. Fan Usage:
Relay:
Filter:
24 Volt In:
120 Volt In:
Gas In:
Extra VL Orifice:
Production Code:
Version: Stock:
Add-On:
Internal Use Only: HEATER
TYPE: Electric:
Tag: Special 1:
Special 2: Gas:
Air: C1
C1 C2 C3
None
N/A
LD3-40
11.13
Two-Stage
Ignition Control
3 PCS Harness
None
None
None
None
IS22016051F5169
Grey (+ / -)
Norton
High
4” Gen.
Yellow - 120V
(Specify TP-#’s)
3140
851B
3252
N/A
N/A
264E
50
201B
1080
828
None
None
None
Fasco Lg.
50Hz - 120V
When Specified
None
None
None
120V Cord
7/8” FC Flare
None
N/A
N/A
55A
55B
N/A
N/A
334
333
83
3
1 1/2”
TP-204#
TP-44# 3
1 5/8”
LLWT038
None 1
1 5/8”
17
1 7/16”
Orifice Type:
SA
MP
LE
Fan
Compartment
Al-Ti Combustion
Chamber
16” Burner Tube
F/N: LL01 - Clearance Safety Tag
(Affix adjacent to heater’s thermostat)
Rating Plate
Aluminized
Radiant Tube(s)
(if applicable)
F/N: LLTCL015
Lighting Instructions
DETROIT RADIANT PRODUCTS COMPANY
21400 HOOVER ROAD - WARREN, MI 48089
(586) 756-0950 www.reverberray.com
LOW-INTENSITY INFRARED HEATER
MAX. HEAT INPUT MAX. DEBIT CALORIFIQUE
MIN. HEAT INPUT MIN. DEBIT CALORIFIQUE
VENT CATEGORY
ÉVENT CATÉGORIE
BTU/h
BTU/h
VOLTAGE
AMPS
PHASE
FREQUENCY
Hz
VAC
MANIFOLD PRESSURE PRESSION A LA TUBULURE D'ALIMENTATION
MAXIMUM INLET PRESSURE PRESSION D'ALIMENTATION MAXIMALE
MINIMUM INLET PRESSURE FOR PURPOSE OF ADJ. PRESSION D'ALIMENTATION EN GAS MIN. ADMISE
INCHES W.C.
INCHES W.C.
INCHES W.C.
RADIATEUR À INFRAROUGE À FAIBLE INTENSITÉ
ORIFICE SIZE DIM DE L'INJECTEUR NATURAL GAS PROPANE GAS
THIS DESIGN COMPLIES WITH STANDARD(S):
COMPLES DE CETTE CONCEPTION AVEC LA NORME:
HEATER BUILD TYPE
TYPE OF GAS TYPE DE GAZ
MIN. MOUNTING ANGLE MIN. ANGLE DE SUPPORT
MAX. MOUNTING ANGLE
MAX. ANGLE DE SUPPORT
MODEL NUMBER
NUMÉRO DE MODÈLE
SERIAL NUMBER
NUMÉRO DE SÉRIE
VERSION
COMBUSTION CHAMBER
®
FOR COMMERCIAL / INDUSTRIAL USE.
FOR INDOOR USE ONLY.
MADE IN U.S.A.
40,000
25,000
CATEGORY III
2.4
SINGLE
60
120 3.5
14.0
5.0
49 D.M.S. 57 D.M.S.
ANSI Z83.20b-2011 • CSA2.34B-2011 RADIANT TUBE HEATER
C1
NATURAL
AGA 7-89 RESIDENTIAL RADIANT TUBE HEATER
0°
45°
LD3-20-40N YYMMREPCSHIPPE#### 09/12
TP-26B; INCH BC ALUMINIZED
SA
MP
LE
F/N: LLTB025R
AVOID EQUIPMENT FAILURE
THIS 10 FT. TUBE IS THE
COMBUSTION CHAMBER.
THIS TUBE MUST BE THE FIRST TUBE
FOLLOWING THE BURNER CONTROL BOX.
! INSTALLER
The combustion chamber utilizes either 409
stainless, titanium alloy or aluminized steel -
depending on the model number of your heater.
Rotate the tube’s welded seam to bottom.
Consult the manual(s) for further details.
F/N: LLTB004
(all heaters with 409 stainless steel tubes)
F/N: LLTB024L
SERVICE ACCESS PANEL
F/N: LLTB026
SERVICE ACCESS PANEL
IGNITER & FLAME SENSE COMPARTMENT
1. Turn off gas & electricity.
2. Remove cover by lifting top
cover upward and outward.
CAUTION: HOT SURFACE.
KEEP COVER IN PLACE. REMOVE FOR SERVICE ONLY.
Bill of Material