Radiant tube assembly – Detroit Radiant Products Company LD3 Series User Manual
Page 16
16
LD3
Series
Radiant Tube Assembly
To install the radiant tubes:
1
Place tubes in hangers with the welded seam facing downward and the swaged end of the tube
towards the exhaust end of the heater system (see Figure 3.6).
Refer to page 22 for tube installation sequence.
2
Slide tube clamps onto radiant tubes (see figure 3.7).
Figure 3.6
•
Attach Hangers
Figure 3.7
•
Attach Tube Clamps
Hanger
Welded seam
faces down
Swaged End
Tube Clamp
Radiant Tube
NOTE: If the tube clamp comes apart, the spacer must be
re-assembled with the spacer’s concave surface facing against
the radiant tube surface.
Concave surface
3.0
Installation
•
Radiant Tube Assembly