AVerMedia Technologies AVERDIGI EB3004 MD - Manual (Page 17)

13
2.2 Using the DVR for the First Time
1. Make sure all devices and power cables are well connected.
2. Turn on the DVR unit by connecting the power cable into the power plug.
3. User should see the SYSTEM INITIALIZE windows appear on the surveillance screen.
The system will do hard disk detection automatically.
4. For the first time use hard disk, please format the hard disk. Using ▲ and
▼
to go
up and down and press to make a selection. Select HDD FORMAT and press
(YES) to format hard disk. If user doesn’t want to format hard disk, press (NO).
5. When is done, HDD FORMAT will show COMPLETE.
SYSTEM INITIALIZE
FW VERSION B2. 01. 01. 00. 01
HDD SIZE 476 , 918MB
HDD FORMAT YES(SELECT)/NO(MENU)
HDD STATUS WAIT . . . .
SYSTEM INITIALIZE
FW VERSION B2. 01. 01. 00. 01
HDD SIZE 476 , 918MB
HDD FORMAT COMPLETE
HDD STATUS WAIT . . . .
6. When hard disk format is done, please adjust the system date and time in order to have
the correct recording date and time.
7. Press to call up the OSD menu, and then, use ▲ and ▼ to select SYSTEM
→ DATE/TIME and press to make a selection.
8. Press and use ▲ and ▼ to select the DATE FORMAT.
9. And then, adjust the DATE and TIME by using to make a selection and using
▲ and ▼ to adjust the date and time.
DATE / TIME SETUP
DATE FORMAT
DATE
TIME
DAYLIGHT SAVING
START
END
OFFSET
YYYY/MM/DD
2009 / 05 / 18
15 : 19 : 09
2009 / 01 / 01 00 : 00 : 00
2009 / 01 / 01 00 : 00 : 00
00 : 00
10. When is done, the DVR system is ready to record.