Magnum Venus Plastech UltraMAX HVLS-1000 Series - Manual (Page 17)

HVLS-1000 Series Fluid Section Manual
Rev. 05/2012 Page | 17
Requirements:
Air Requirements:
Clean, dry compressed air must be available at up to 90 psi (6.3 kg/cm 2 ) and a minimum volume
of 14 CFM (0.4 m 3 ). Air must be provided through an air hose with a diameter of 0.5 inch (1.3
cm) or greater.
Tool and Supplies Requirements:
When performing service and repair on the Fluid Section, you should have the following tools,
spare parts and supplies available before beginning.
NOTE: Items followed by a * may be purchased from Magnum Venus Plastech.
One table vise
Loctite™ 243 (removable) or equivalent thread lock compound
One small hammer
Needle-nose pliers
Solvent or emulsifier for cleaning
One clean work table
Set of hex wrenches * (08469)
One 5/8-inch wrench * (08474)
One 9/16-inch wrench * (08476)
One 5/16-inch wrench * (08477)
Empty buckets for cleaning
Clean ¼-inch plastic dowel or rod
One 8-inch adjustable wrench * (08467)
One 12-inch adjustable wrench * (08468)
One 7/16-inch open-end wrench
One ½-inch socket wrench
One 7/16-inch socket wrench * (08472)
Wooden sticks or tongue depressors (for testing)
Labels and pens (for marking pneumatic lines)
Clean rags and paint brushes for cleaning equipment
One tube of medium-weight lithium grease (such as Lubriplate ® lubricant * (08465))
Large (approximately 3 feet by 10 feet or 1 meter by 3 meters) strips of paper for
performing spray tests.
One pin wrench * (45031-1) (comes with catalyst jug)
One scribe * (08126)
Red Grease * (6706-2-1 1oz can) (6706-2-16 16oz can) (6706-2-32 32oz can)
Seal Kit * -
HVLS-1000-SK Seal Kit – High Volume Fluid Section
HVLS-10SK-4U-1T Seal Kit – four HVLS-1010-U Packings