Magnum Venus Plastech UltraMAX HVLS-1000 Series - Manual (Page 16)

HVLS-1000 Series Fluid Section Manual
Rev. 05/2012 Page | 16
Lubrication:
Throughout this manual, directions are given for lubricating various parts of the Fluid Section.
There are three types of lubricant used:
If the part contacts resin, use MVP Red Grease (6706-2-1).
If the part is located where it will contact air, use Lubriplate ® (08465).
Throat Seal Oil (TSL-3200) used in the oil reservoir of the pump.
DANGER: FIRE AND EXPLOSION HAZARD. Never use any lubrication on the
components of the catalyst system. Contact your catalyst manufacturer for additional
material handing information.
Major Components:
Resin Pump Fluid section.
Description of Controls for Spray unit:
Familiarize yourself with the manifold controls, which consist of the following regulators and
gauges:
PUMP PRESSURE gauge and regulator. These control main air pressure to the
resin pump.
ATOMIZING-AIR gauge and regulator. This controls the air pressure to the catalyst
nozzle on the gun.
PRIMING BUTTON this control is to operate the pump with triggering the gun.
Hazard Information:
Please note the following safety and informational designations used throughout this manual:
DANGER: Indicates hazards or unsafe practices that are likely to result in severe
personal injury or death.
WARNING: Indicates hazards or unsafe practices which could result in severe personal
injury or extensive equipment damage.
CAUTION: Indicates hazards or unsafe practices which could result in minor injury or
damage to equipment.
NOTE: Indicates additional information including explanations of certain procedures or
helpful suggestions. Notes do not contain safety information.