Impulse 150PoE - Manual (Page 30)

©Sealevel Systems, Inc.
SL9049 - 03/2011
eI/O Manual 30
Type
Cd “C:\Program Files\Sealevel Systems\SeaMAX\” and then press Enter
When the command calls for iii.iii.iii.iii you substitute the unit‟s IP address. Please do not enter
the numbers with a leading zero. Therefore, if your IP address is 192.168.42.11, you will enter
192.168.42.11 and not 192.168.042.011. The command for this is therefore:
iocu /i=192.168.42.11 /a=247 120.hex
Once the unit has received the download request it will turn on the ACT light . Once the
download starts, the ACT light will flash rapidly as data is downloaded. Once the download is
complete, the ACT light will remain on while the device is reprogramming itself.The unit will
then reboot itself to reload the new firmware. At this point, the ACT light will turn off.
The above should only be performed if you (1) really feel the update is required and (2)
you feel confident in your ability to perform the update. Once the firmware has been
erased, you must either be able to re-program it locally or send it back to SeaLevel
Systems, Inc. for reprogramming.
To upgrade your firmware through MaxSSD, connect to your device normally, then go to the
“Advanced” tab. At this point, you can use the “…” button to browse for the *.hex file you wish
to update your device with.