Controlled Products Systems Group L3NX - Manual (Page 17)

VIKING TECHNICAL SUPPORT 1.800.908.0884 1 5
Post Mounting Option
TIP:
The operator is equipped for post mount applications and is ready for installation.
You will only need to supply the posts and u-bolts.
1. Consult the local building codes for the depth and concrete requirements.
2. Maximum 3.00” OD pipe.
3. Provide a sufficient number of conduit pathways for all low power acces-
sories such as loop detector leads, maglock, non-contact sensors, contact
sensors, safety and other commands. Also provide conduit for the power
supply to the operator.
!
DO NOT run low voltage and high voltage wiring in the same conduit.
!
Provide at least 12” separation between low and high voltage conduits.
GATE OPERATOR INSTALLATION