CTI Products NCB/FL with Fiber Interface - Manual (Page 7)

CTI Products, Inc. NCB-EL/FL User Guide
2. Installation 4
Control Neuron Processor
The Control Neuron Processor provides access to IP address parameters. Ethernet channel parameters can be
configured and displayed using the EtherPlug program. The Control Neuron Processor acts as another
L
ON W ORKS node on the network. It is connected to Side A of the router module, and appears to be located on
the Ethernet channel.
Ethernet Port
The 10BaseT and AUI connectors implement IEEE standard Ethernet at 10 Mbps. OPTION switch positions 7
and 8 are used to select which connector is active. See Step 6 in the I
NSTALLATION section.
The NCB-Etherlon Network Combiner utilizes IP (Internet Protocol) to implement the link to other NCB-
Etherlon units. Both Unicast/Replicated and Multicast addressing is supported using UDP transport.
“A
PPENDIX F. IP A DDRESSES ” provides more detail about IP addressing.
The IP “port numbers” used by the NCB-Etherlon and NCB-Fiberlon are 1100 (destination) and 1283 (source).
R
EFERENCE
D
OCUMENTS
The following additional information is available from the sources indicated.
Document Source Reference Number
Message Buffer Configuration CD ROM or www.ctiproducts.com Technical Note TN010
Combining Multiple
L
ON W ORKS Networks using
Unicast/Replicated vs.
Multicast IP Addressing
CD ROM or www.ctiproducts.com Technical Note TN020
SMX Transceiver Installation CD ROM or www.ctiproducts.com Technical Note TN025
NCB Installation with Network
Management Tools CD ROM or www.ctiproducts.com Technical Note TN026
L ON W ORKS Router User’s
Guide
Echelon 078-0018-01B