CTI Products PCLTA PCI Interface - Manual (Page 28)

PCLTA Installation Manual System Considerations
CTI Products, Inc.
68-11199-135
24
Enter this on the second line denoted by Config Filename: as shown below.
Click the OK button when you are finished.
Note: for this example, a configuration file named: MCNRCD.NT was created
by copying the original CONFIG.NT file and adding the extra line for the PCLTA
device driver. The installing technician may use any filename as long as that file
contains the PCLTA device driver entry.
You can make a MCNCFG.EXE program ‘shortcut’ Icon similar to the
MCNRCD.EXE Icon previously mentioned. The MCNCFG.EXE program
properties does not require any changes to the standard Windows NT settings,
since it does not use the PCLTA drivers..
Installation and Setup of the MCNRCD.EXE program and the PCLTA card are
for Windows NT/2000/XP Workstation are now completed.
Please refer to your MCN RCD and PCLTA manuals to run the MCN RCD
system software.
If you have difficulties with the PCLTA device driver not loading, see Section 9,
Troubleshooting.
7.5 MCNRCD Relay Outputs
Relay outputs are not supported on Windows 95, 98, NT, 2000, or XP.