CTI Products HIB-IP IP Interface - Manual (Page 9)

CTI Products, Inc. HIB-IP & HIB-IP 8000 Hardware Reference Manual
1. Introduction 9
HTTP Page Security Note
The HIB-IP and HIB-IP 8000 units have an HTTP page that shows the status of the unit, including the IP
parameters programmed into it and its On-Line / Off-Line status. This is useful for system troubleshooting.
This feature is turned off at the factory by default for HIB-IP 8000 units.
If your network security policies allow you to use HTTP pages and you desire to have the HTTP page turned on
for troubleshooting, set Switch 2 Up and reset the unit.
If your network security policies mandate against this type of data being accessible through HTTP pages, verify
that the HTTP page by setting Switch 2 Down and resetting the unit. For further security, restrict physical
access to the unit and the networks to which it connects.
Note: Some networks (including Motorola Solutions, Inc. Radio Network Infrastructure - RNI) have routers
and or firewalls that restrict HTTP traffic between certain network segments. If you have such a system, you
may not be able to open the HTTP page from a different IP subnet, even if you have the HTTP page enabled on
the HIB-IP unit.