CTI Products HIB-IP IP Interface - Manual (Page 13)

CTI Products, Inc. HIB-IP & HIB-IP 8000 Hardware Reference Manual
3 Installation 13
3. I
NSTALLATION
P
HYSICALLY
I
NSTALL
HIB-IP U
NIT ONTO THE
IP N
ETWORK
A) Set Option Switches:
• Set up the OPTION switches for the desired operation.
1 2 3 4 5 6 7 8 ON
Function Up Down Default
1. Must be Up Up
2. HTTP Enable HTTP On HTTP Page Off Down
3. Must be Down Down
4. Must be Up Up
5. Must be Up Up
6. Must be Up Up
7. Must be Up............................................. Up
8. Must be Up ........................................ Up
The default settings should be suitable for most applications.
Less restrictive security:
Some system policies require that the HTTP page be turned off. For systems that allow the HTTP
page to be displayed for diagnostic purposes s, you may set Switch 2 Down to disable the HTTP status
page.
B) Mount the HIB-IP units (See Appendix B for Mounting Option details):
Desk, Wall, or Rack Mounting
• Non-slip rubber feet are included on all HIB-IP modules to allow them to conveniently rest on any
horizontal surface. Four 6-32 threaded holes are also available on the bottom of the module to
allow bolting of the module in any convenient orientation. WARNING: Care should be taken to
limit protrusion of the screw into the module to no more than 0.125 inch from the module
bottom surface!
• Mounting kits are available as options to allow wall or rack (19” EIA) mounting of the HIB-IP
modules.
C) Make electrical connections (See Appendix C for connector details):
Grounding
• When wall or rack mounting the HIB, a suitable safety and protective earth ground should be
provided to the metal enclosure. The protective earth ground provides a path to ground for
electrostatic discharge (ESD) energy. This connection is most conveniently made directly to the
wall mount bracket or rack plate.