beautypg.com

Enable or disable check flip test mode – CognitiveTPG A760 User Manual

Page 36

background image

Chapter 4: Using the Printer

36

A760 Two-Color Thermal/Impact Hybrid Printer: User Guide

189-9200303 Rev. D

A760-D100 10/04

Enable or disable check flip test mode

The check flip test verifies that the check flip mechanism will flip an inserted check only. It
does not read the check. Check flip test is enabled or disabled by selecting the “Diagnostic
Modes” sub-menu of the configuration menu. See “Configuring the printer”, page 32 for
instructions on how to enter the configuration menu.

Extended

slip table

DO NOT WRITE, ST

AMP OR SIGN BELOW THIS LINE

FEDE

RAL R

ESER

VE B

OA

RD O

F G

OVER

NO

R'S RE

G. CC

RESE

RVE

D FO

R FIN

ANC

IAL IN

STITUTIO

N U

SE

Slip

table

Check

guide

Green

slip-in LED

Check orientation - face down

Do not fold check

ENDORSE HERE

MEMO

Paper feed

button

To run the check flip test mode:

1

Enable the check flip test mode.

2

Exit the configuration menu.

3

Insert a check, lengthwise and face down into the
slip station as if validating. (See “Verifying and
validating checks,” page 28.)

Note: You must use a check to conduct the test. The test
will not run if a slip or form is inserted.

4

Push paper feed button.

The check is flipped and returned, but no printing is
performed.

To exit the check flip test mode:

1

Enter the configuration menu and “Diagnostic
Modes”
sub-menu again. (See page 32.)

2

Disable the Check flip test mode.

3

Exit the configuration menu.

The printer is on-line and can again normally
communicate with the host computer.