CNB PM1063P - Manual (Page 14)

◎ Adjust mask size. Use joystick or arrow buttons to
adjust mask size.
◀▶ (LEFT/RIGHT) : Adjusts mask width.
▲▼ (UP/DOWN) : Adjusts mask height.
◎ Setup the general functions of zoom camera module.
• FOCUS MODE [AUTO/MANUAL/SEMIAUTO]
- Sets camera focus mode.
SEMIAUTO Mode
This mode exchanges focus mode automatically between
Manual Focus mode and Auto Focus mode. Manual
Focus mode activates in preset operation and Auto Focus
mode activates when jog operation starts. With Manual
mode at presets, Focus data is memorized in each preset
in advance and camera calls focus data in
correspondence with presets as soon as camera arrives
at a preset.
• DIGITAL ZOOM [ON/OFF]
- Sets digital zoom function to ON/OFF. If this is set to OFF, optical zoom function runs
but zoom function stops at the end of optical zoom magnification.
• IMAGE FLIP [ON/OFF]
- If IMAGE FLIP is ON, Current image is reversed. If IMAGE FLIP is OFF, Reversed
image will recover to previous status.
• WB MODE [AUTO/MANUAL]
- In Manual mode, Red and Blue level can be set
up manually.
• RED ADJUST [10~60]
• BLUE ADJUST [10~60]
• BACKLIGHT [ON/OFF]
- Sets Backlight Compensation
• DAY/NIGHT [AUTO1/AUTO2(0~255)/DAY/NIGHT]
- AUTO1 exchanges Day/Night mode faster than
AUTO2. You are able to adjust Day/Night sensitive
level if you have selected AUTO2 mode.
If Day&Night sensitive level has the higher value,
it excute that change Day&Night in the lower
luminance.
• BRIGHTNESS [0~100]
- Adjusts brightness of images. Iris, Shutter Speed and Gain are adjusted automatically in
correspondence with this value.
• IRIS [AUTO/MANUAL(0~100)]
- If Iris is set to Auto, Iris should have highest priority in adjusting AE and Shutter Speed
should be fixed. If Iris is set to Manual, Iris should be fixed and Iris has lower priority in
adjusting AE, in comparison with others.
• SHUTTER SPEED [ESC/A.Flicker/Manual(x128~1/120000sec]
- If Iris is set to Manual and Shutter Speed is set to ESC, Shutter Speed should have
highest priority. If Shutter Speed is set to A.Flicker, to remove Flicker, Shutter Speed
should be set to 1/100 sec. for NTSC and 1/120 for PAL. If Shutter Mode is set to
MANUAL, Shutter speed is able to adjust from x128 to 1/120000.
• AGC [OFF/NORMAL/HIGH]
- Enhances image brightness automatically in case that luminance level of image signal is
too low.
• SSNR [OFF/LOW/MIDDLE/HIGH]
- Enhances images by deducting noises when gain level of images is too high.
• SENS-UP [AUTO(2~128)/OFF]
- Activates Slow Shutter function when luminance of image (signal) is too dark.
It is possible to set up the maximum number of frames piled up one on another by Slow
Shutter function.
PRIVACY ZONE SIZE ADJUSTMENT
CAMERA SETUP
WHITE BALANCE SETUP
AUTO EXPOSURE SETUP
EDIT MASK 1
[ ◀▶ :ADJUST MASK WIDTH ]
[ ▲▼ :ADJUST MASK HEIGHT ]
[NEAR :SAVE /FAR :CANCEL ]
CAMERA SETUP
FOCUS MODE
BACK
DIGITAL ZOOM
IMAGE FLIP
>
>
EXIT
SEMIAUTO
ON
OFF
☞
WB SETUP ▬ GLOBAL
WB MODE
BACK
├ RED ADJUST
└ BLUE ADJUST
EXIT
AUTO
▬ ▬ ▬
▬ ▬ ▬
☞
AE SETUP ▬ GLOBAL
BACKLIGHT
BACK
EXIT
OFF
DAY /NIGHT
BRIGHTNESS
IRIS
SHUTTER
AGC
SSNR
SENS ▬ UP
< AUTO 2>
25
AUTO
ESC
HIGH
MIDDLE
< AUTO >
☞
26 27