CNB PM1063P - Manual (Page 11)

• Function : By using Swing function, you can make camera to move between 2 Preset
positions repeatedly. When swing function runs, camera moves from the
preset assigned as the 1st point to the preset assigned as the 2nd point.
Then camera moves from the preset assigned as the 2nd point to the preset
assigned as the 1st point. Speed can be set up from 1°/sec to 180°/sec.
You can not set the same preset.
• Set : To set Swing, use OSD menu.
• Run : Method 1) Run Pattern [Swing NO.+10] ex) Run Swing 3 : Run Pattern [13]
Method 2) Go Preset [Swing NO.+140] ex) Run Swing 3 : Go Preset [143]
• Delete : To delete Swing, use OSD menu.
• Function : Pattern Function is that a camera memorizes the path (mostly curve path)
by joystick of controller for assigned time and revives the path exactly as it
memorized. 4 Patterns are available and Maximum 1200 communication
commands can be stored in a pattern.
• Setting : Pattern can be created by one of following two methods.
Method 1) [Pattern NO.]
- Pattern editing screen is displayed as bellow.
- Movement by Joystick and preset movement
can be memorized in a pattern.
- The rest memory size is displayed in progress bar.
- To save the recording, press NEAR key and to
cancel, press FAR key.
Method 2) OSD using OSD menu: See the section “How to use OSD menu”.
• Run : Method 1) Run Pattern [Pattern NO.] ex) Run Pattern 2 : Run Pattern [2]
Method 2) Go Preset [Preset NO.+130] ex) Run Pattern 2 : Go Preset [132]
• Delete : To delete Pattern, use OSD menu.
• Function : The group function allows running sequence of Presets, Pattern and/or
Swings. Max 8 group can be stored. Each group can have max 20 action
entities which can be preset, pattern or swing. Preset speed can be set up
and the repeat number of Pattern & Swing can be set up in Group setup.
Dwell time between actions can be set up also.
• Set : Use OSD menu to create a Group.
• Run : Method 1) Run Pattern [Group NO.+20] ex) Run Group 7 : Run Pattern [27]
Method 2) Go Preset [Group NO.+150] ex) Run Group 7 : Go Preset [157]
• Delete : To delete Group, use OSD menu.
SWING
PATTERN
GROUP
Preset 1 Pattern 1 Swing 1
DWELL TIME
Max. 20 Action
EDIT PATTERN 1
[NEAR:SAVE /FAR:DELETE ]
■■■■■■ ■■■■■■ ■■■■■■■
0/0/x1/N
20 21