CNB PM1063P - Manual (Page 10)

• Function : Using the OSD menu, Preset, Pattern, Swing, Group and Alarm Input
function can be configured for each application.
• Enter Menu : Go Preset[95]
• Description : Some Preset numbers are reserved to special functions.
• Function :
• Function : Max. 127 positions can be stored as Preset position. The Preset number
can be assigned from 1 to 128, but 95 is reserved for starting OSD menu.
Camera characteristics (i.e. White Balance, Auto Exposure) can be set up
independently for each preset. Label should be blank and "Camera Adjust“
should be set to "GLOBAL" as default. All characteristics can be set up in
OSD menu.
• Set : Set Preset [1~128]
• Run : Go Preset [1~128]
• Delete : To delete Preset, use OSD menu.
◎ Before power is applied, please check the cables carefully.
◎ The camera ID of the controller must be identical to that of the target camera.
The camera ID can be checked by reading DIP switch of the camera.
◎ If your controller supports multi-protocols, the protocol must be changed to match to
that of the camera.
◎ If you changed camera protocol by changing DIP switch, the change will be effective
after you reboot the camera.
◎ Since the operation method can be different for each controller available, refer to the
manual for your controller if camera can not be controlled properly. The operation of
this manual is based on the standard Pelco® Controller.
◎ Check how to operate preset and pattern function with controller or DVR in advance to
operate camera function fully when using controller or DVR.
◎ Refer to the following table when using standard Pelco® protocol controller.
◎ If controller or DVR has no pattern button or function, use shortcut keys with preset
numbers. For more information, refer to “Reserved Preset” in this manual.
Check points before operation
Preset and Pattern Function Pre-Check
Starting OSD Menu
Reserved Preset
PRESET
Go Pattern Input [Preset No.] and press [Preset] button shortly.
Set Pattern Input [Preset No.] and press [Preset] button for more than 2 seconds.
Run Pattern Input [Pattern No.] and press [Pattern] button shortly.
Set Pattern Input [Pattern No.] and press [Pattern] button for more than 2 seconds.
18 19
Go Preset[95] : Enters into OSD Menu.
Go Preset [131~134] : Runs Pattern Function 1~4
Go Preset[141~148] : Runs Swing Function 1~8
Go Preset[151~158] : Runs Group Function 1~8