CNB ISS2965PW - Manual (Page 9)

bâàwÉÉÜ fÑxxw WÉÅx fxÜ|xб |С@åÇxà
9
2. Installation
⊙ DIP Switch Setup
■ Before installing the camera, you should set the DIP switches to configure the camera ID, communication protocol. Do not use the system upgrade
terminal.
■ Input Sensor Active Type
• When a sensor input is used, its functional type should be set.
There are two types; Normal Open type and Normal Close type.
-Normal Open : Voltage is let out when the sensor is activated
-Normal Close : Voltage is let out when the sensor is not activated
Pin Switch position Sensor type
ST1 (Pin 4)
ON Sensor 1 Normal Close
OFF Sensor 1 Normal Open
ST2 (Pin 5)
ON Sensor 2 Normal Close
OFF Sensor 2 Normal Open
ST3 (Pin 6)
ON Sensor 3 Normal Close
OFF Sensor 3 Normal Open
ST4 (Pin 7)
ON Sensor 4 Normal Close
OFF Sensor 4 Normal Open
• If a wrong type of sensor is selected, it activates in the opposite way to the sensor input.