CNB ISS2965PW - Manual (Page 32)

bâàwÉÉÜ fÑxxw WÉÅx fxÜ|xб |С@åÇxà
32
4. OSD Menu
⊙
Motion Setup
Setup the general functions of Pan/Tilt motions.
• MOTION LOCK
[ON/OFF]
If Motion Lock is set to ON, it is impossible to set up and delete Preset
Swing, Pattern and Group.
It is possible only to run those functions. To set up and elete those
functions, enter into OSD menu.
• PWR UP ACTION [ON/OFF]
Refer to “Other Functions” section.
• AUTO FLIP [ON/OFF]
Refer to “Other Functions” section.
• JOG MAX SPEED [1°/sec~360°/sec]
Sets maximum jog speed. Jog speed is inversely proportional to zoom
magnification. As zoom magnification goes up, pan/tilt speed goes
down.
• JOG DIRECTION [INVERSE/NORMAL]
If you set this to ‘Inverse’, the view in the screen is moving same
direction with jog tilting. If ‘Normal’ is selected, the view in the screen
is moving reversely.
• FRZ IN PRESET [ON/OFF] (30x (EXview), 27x, 36x Models Only)
If “Freeze in preset” function mode is ON, camera starts freezing the
image of start point at start point of preset movement. Camera keeps
displaying the image of start point during preset movement and does
not display the images which camera gets during preset movement.
As soon as camera stops at preset end point, camera start displaying
live images which it gets at preset end point.
This function is only available with 30x (EXview), 27x ,36x Models.
■ PARK ACTION SETUP
If Park Enable is set to ON, camera runs assigned function automatically if there is no PTZ
command during assigned “Wait Time”.
• PARK ENABLE
[ON/OFF]
• WAIT TIME [1 minute ~ 4 hours]
The time is displayed with “hh:mm:ss” format and you can change this
by 1 min unit.
• PARK ACTION [HOME/PRESET/PATTERN/SWING/GROUP]
If it is set to “HOME”, all the functions go back to “HOME” position
(PAN,TILT, ZOOM)=(0, 0, x1).