CNB ISS2965PW - Manual (Page 66)

bâàwÉÉÜ fÑxxw WÉÅx fxÜ|xб |С@åÇxà
66
Field Sub Field Description
IPv4 Address
Configuration
Enable DHCP
(default)
Turns DHCP on or off.
Check DHCP checkbox to get an IP address automatically from the network using DHCP
protocol. Obtained IP address can be viewed by IP Installer.
(Note) If the network does not use DHCP server, the product will wait for server’s response for
two minutes and restart with its previous IP address.
IP address
Enter an IP address.
Configure IP address after checking IP address range configuration of the router where the
XNET product is connected.
Subnet mask
Enter Subnet mask.
Use this when you want to access only from the same subnet by masking out upper portion of
the IP address.
Use 255.255.255.255 when you want to connect from one PC only.
Default router Enter the address of Default router.
DNS
Configuration
Domain name Enter Domain name.
Primary
DNS Server
Enter primary DNS address.
Secondary DNS Server Enter secondary DNS address.
NTP Configuration Network address
Enter address of NTP (Network Time Protocol Server.)
NTP server is used when “Synchronize to NTP Server” is selected in Date&Time page.
Host name
Configuration
User
the host name
Enter Host name
Ethernet(MAC)
Address
MAC
address
Enter Ethernet Address.
Save - Applies and saves changes.
Reset - Recalls previously saved configurations.