CNB ISS2965PW - Manual (Page 15)

bâàwÉÉÜ fÑxxw WÉÅx fxÜ|xб |С@åÇxà
15
3. Operation
⊙
Check Points before Operation
• Before power is applied, please check the cables carefully.
• If you changed camera protocol by changing DIP switches, the change will be effective after you reboot the camera.
⊙ S
ystem Control
•
Logging On
You can log on as an administrator using either Internet browser or ‘CMS’ software.
(This manual will describe about using Internet browser only.)
•
Using Internet Explorer
Type the IP Address of the XPEED-XNET product in the address bar and press enter.
Ex) : http://192.168.123.100
If the HTTP port has been changed from the default value, enter the new port as shown below:
IP Address of the XPEED-XNET: Port No.
Ex) : http://192.168.123.100:8080
•
ID and Password
If you are logging in as an administrator, the Log-In box will appear as shown in figure 3-1.
Basic Setup page will appear when you enter id and password.
The default user name and password is “ root ” and “ admin ” respectively.
If you forget the administrator’s password, “Factory Reset” is the only way to regain access. However, since this will retrieve all
default settings, you need to configure the network settings using IP installer software again.
For security purpose, it is recommended to change the administrator’s id and password from their default values. Please be careful not
to forget them or expose them to others. Please refer to [figure 5-5] for detail.