Chapin 82125 - Manual (Page 9)

CHAPIN INTERNATIONAL, INC. P.O. BOX 549 700 ELLICOTT ST. BATAVIA, NY 14021-0549 www.chapinmfg.com 800-950-4458
START RESTART RESTART
RESTART RESTART
SHUT OFF HERE SHUT OFF HERE
SHUT OFF HERE SHUT OFF HERE
Sample Spread Pattern
• When finished spreading empty hopper of any remaining material.
• Thoroughly wash spreader and allow to dry before storing.
• Gears are permanently lubricated at the factory. DO NOT open the gearbox at anytime as debris may enter
and interfere with functionality.
• When using rock salt and ice-melt products be sure to empty the hopper upon completion of spreading each
time you use it. These materials may reconstitute back into a solid block overnight with humidity. They can also
damage metal parts if exposed for extended periods of time.
STORAGE AND MAINTENANCE
Scotts 2 2.5 3 3.25 3.5 4 4.75 5 5.5 6 7 8 9 10 11 12 13 14 15
Chapin 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27
All Season Residential & Professional Push Spreader Application Conversion Chart All Season Residential &
Professional General Application
Guidelines
Weed Control
Fertilizer
Grass Seed - Overseeding
Grass Seed - New Lawn
Salt & Ice-Melt 10-12
12-16
16-20
21-27
28-30
APPLICATION CHART
• Be sure gate control is in the closed position.
• Determine appropriate setting for material being used by reading the suggested setting on the material’s bag
AND/OR by referencing the application chart on your spreader’s control panel (Charts provided are only guidelines.
Be sure to read the instructions on the bag/box of the material you’re spreading to identify accurate setting needed)
• Set the dial to the desired setting Important Note: Do not adjust dial with gate open.
This will alter the accuracy of gate settings and cause parts to break.
• To begin spreading, start walking (about 3 mph pace) and pull the gate control down to open gate.
• To stop spreading simply push gate control up and the gate will close.
GENERAL OPERATING INSTRUCTIONS