beautypg.com

Chapin 1449 User Manual

Warning, Parts, piezas, pièces, Hose to tank 2. nozzle

background image

Hazard: Improper use or failure to follow instructions can result in explosive failure causing serious eye

or other injury.

For safe use of this product you must read and follow all instructions. Do not leave a pressur-

ized sprayer in the hot sun. Heat can cause pressure build-up. Do not store or le

ave solution in tank after use.

Always wear goggles, gloves, long sleeve shirt, long pants and full foot protection when spraying. Never use

any tool to remove pump if there is pressure in sprayer. Never stand with face or body over

top of tank when

pumping or loosening pump to prevent ejecting pump assembly and/or solution from striking and injuring

you. Never pressurize sprayer by any means other than the original pump. Do not attempt to modify or repair

this product except with original manufacturer’s parts. Never spray flammable materials or heat, pressure, or

gas producing chemicals. Always read and follow manufacturer’s instructions before use with this sprayer

as some chemicals may be hazardous when used with this sprayer.

WARNING!

Sk-1113-1

Parts, Piezas, Pièces

6-6141

Hose

Manguera

Tuyau

6-1866

Shut-off Handle

Mango de cierre

Poignée du robinet

Note:

Your particular sprayer may not include all parts pictured above.

Nota:

Es posible que este pulverizador en particular no incluya todas las partes que se ilustran arriba.

Remarque :

Votre pulvérisateur particulier pourrait ne pas inclure toutes les pièces illustrées plus haut.

Repair Parts Kit Gaskets and Seals (not included),

Juego de piezas de reparación, empaquetaduras y juntas (no incluido)

Kit de pièces de réparation, joints et garniture d’étanchéité (non inclus) 6-4629

1. Hose to Tank

2. Nozzle

Make sure hose is pushed all

the way to the tank. Make sure

hose clamp is tight and below

the hose barb. Turn clockwise

with a screwdriver to tighten.

Attach nozzle to shut-off handle or extension wand.

1) Do: Check tightness of hose nut to be sure hose is securely attached to the tank outlet.

2) Do: Inspect hose for deterioration, cracks, softness, or brittleness. If any of these conditions are found,

replace hose before using. Replace with original manufacturer’s parts only.

3) Do: Remove pump (see Filling, Pressurizing and Spraying Instructions), inspect interior and exterior of

tank for signs of deterioration of body and bottom. Any sign of deterioration indicates possible tank

weakening and could result in explosive bursting under pressure. If any of these signs are found, discard

tank immediately and replace. Do not attempt to patch leaks, etc., as this could result in serious injury.

4) Do: Follow Filling, Pressurizing and Spraying Instructions, except use water only.

5) Do: Pump plunger 10-2 0 strokes and inspect for leaks.

6) Do: Direct shut-off away from you and open to make sure discharge is not clogged.

7) Do: If unit passes this test, release pressure (see Pressure Releasing Instructions), empty tank, and proceed

with Filling, Pressurizing and Spraying Instructions.

3. Pre-Use Check

4. Filling

1) Do: Turn pump handle counterclockwise and remove pump

2) Do: Prepare spray solution following all directions and safety warnings on chemical label.

3) Do: Fill tank to no more than the proper gallon marker. Do NOT: overfill to accommodate pump.

4) Do: Check pump to make sure that no grass or dirt is stuck to barrel. Replace pump in tank and

tighten securely.

5. Pressurizing and Spraying

7. Care, Storage and Maintenance

1) Do: Rinse tank thoroughly with water only, empty, refill with water. Follow Filling, Pressurizing and

Spraying Instructions, except pump unit only 8-10 strokes.

2) Do: Open shut-off and allow water to run through discharge assembly.

3) Do: Release pressure (Follow Pressure Release Instructions), remove pump and empty sprayer.

4) Do: Store sprayer tank upside down, with pump removed, in a warm dry location.

5) Do: Periodically oil pump by dropping 10-12 drops of light oil down pump rod through opening in

cover.

6-7703

Extension wand,

Vara de extensión, Rallonge

WARNING:

Handling the brass parts of this product will expose you to lead, a chemical

known to the State of California to cause birth defects and other reproductive harm. Wash

hands after handling.

Congratulations!

You have just purchased a quality Chapin product.

Register Your Sprayer Online @ www.chapinmfg.com

Questions?

Do Not Return To Store.

Call us @ 1-800-950-4458 or www.chapinmfg.com

¡Felicitaciones!

Usted acaba de adquirir un producto de calidad Chapin.

Registre su pulverizador en línea en www.chapinmfg.com

¿Preguntas?

No regrese a la tienda;

llámenos al 1-800-950-4458 o visite www.chapinmfg.com

Félicitations!

Vous avez acheté un produit de qualité Chapin.

Enregistrez dès que possible votre pulvérisateur en ligne à l'adresse

suivante:

www.chapinmfg.com

Questions ?

Ne retournez pas au magasin.

Appelez-nous 1-800-950-4458 ou visitez le www.chapinmfg.com

2-1051-48 (A) R0610

6-5797

Nozzle .5GPM

Tobera

Buse

6-5373

Holster

Funda

Étui

6. To Release Pressure

1) Do: With pump facing away, turn locked handle counterclockwise until air begins to escape.

Stop turning handle when you hear air escaping.

2) Do: Stay away from the sprayer until all air has escaped.

6-3337

Strap

Correa

Sangle

8. Install Holster

A.

Squeeze shut-off

handle.

B.

Place shut-off handle

through holster opening.

C.

Push through open-

ing in holster.

D.

Feed holster down

hose.

E.

Push holster over outlet.

F.

Slide holster in clip.

G.

Lock bottom of

holster in clip on

side tank.

Hose Barb

H.

Assembled

Pump until you

feel resistance.

Turn handle clockwise

to tighten.Push handle

down, turn 1/4 turn

counterclockwise to

release.

Push handle, down, turn 1/4

turn clockwise to lock. Begin

spraying.Re-pump sprayer as

required to maintain spray

force.

5a

5b

5c

1a

2a

2b