Kolpin 21516_21517 – KXP DOUBLE RHINO GRIP User Manual
Page 2
21516_21517rev.02
Kolpin Outdoors, Inc., 205 N. Depot Street, Fox Lake, WI Phone #: (877) 9KOLPIN or (920) 928-3118
www.kolpin.com
21517 Assembly:
1.
Place the smaller rubber expander on the threaded rod.
* NOTE: the rubber expander for both systems has a counter-bored
relief that mates to the threaded rod. Please be sure to install
correctly!
2.
Slide the plastic spacer onto the threaded rod.
3.
Slide the larger rubber expander onto the rod.
4.
Place the nylon washer on top of the large rubber expander and
thread the rod into the threaded insert in the bottom of the base.
5. Place the connector into the doubler plate.
6. Place the M6 black nylon locking nut into the bottom of the connector,
so that the nylon part of the nut is facing out towards you.
7. Take the flat head machine screw and tipping the doubler plate so that
the connector is facing upwards; start twisting the machine screw until it
engages the nut in the connector. Tighten securely.
8. Place the 2 extra Kolpin logos over the flat head screw.
9. Insert the doubler plate assembly into the mounting base, already
attached to ATV, and position as desired.
10. Secure the double plate assembly to the mounting base using the Kwik
clip provided.
11. Insert the Rhino Grips in the desired position on the doubler plate and
secure using the Kwik Clips provided. NOTE: Grip can rotate 360° to
accommodate any angle, and the grip can tilt 0° to 180° at 45°
increments.
12. Repeat on opposite side of vehicle.