Kolpin 20096_20097 – KXP GUN BOOT 5.0 - Manual

Rev. 1
Kolpin Outdoors, Inc., 205 N. Depot Street, Fox Lake, WI Phone #: (877) 9KOLPIN or (920) 928-3118 www.kolpin.com [email protected]
20096/20097 – KXP GUN BOOT 5.0
ATV Bracket Assembly Instructions:
1. Attach the Bracket Plate to the Base Plate using the (3) 5/16" Carriage bolts, (3) flat washers and (3) 5/16” Nylon
nuts. Tighten loosely until final positioning is completed when the bracket is on the machine.
2. Next, insert the Spline through the Gun Boot Bracket as shown above in the illustration.
3. Place the Dust Cover on the back side of the Spline. Attach the Boottector Bracket to the Spline and the Dust Cover
using (4) ¼” x 3/4” Truss Head Bolts, and (4) ¼” Nylon Nuts, with the Nylock Nuts on the back side of the Dust
Cover. Do not fully tighten, as the spline is adjustable in the slotted bracket for fine-tuning the angle of the Gun
Boot to your ATV.
4. Attach the (2) – KXP PLUNGERS to the base plate. Align the bracket on the ATV rack so the both plungers line up
with the existing mount locations. Simply place the threads of the plunger through the holes on the Base Plate
and thread on the KXP Handle. The picture shown at the top is how the KXP Plungers will be if you are mounting
this to the right side of the ATV. This bracket is designed to work on either the left or right side of the vehicle.
5. Make sure the bracket is flat on the rack and tighten each KXP plunger securely.
6. Attach the Gun Boot V on the spline at the desired angle. Insert the Gun Boot for a test fit, and at this point, you
can make small adjustments by rotating the Gun Boot and letting the mounted spline assembly move slightly in
the slots. When you get to the desired location, take the Gun Boot off the spline and tighten the (4) bolts holding
the spline assembly to the bracket.
7. Secure the Gun Boot to the bracket with the turn knob.
CAUTION: Always make sure gun is unloaded before placing it in your Gun Boot!
NO. Description QTY.
1 Gun Boot Bracket 1
2 Mounting Base Plate 1
3 Dust Cover 1
4 Spline 1
5 Turn Knob 1
6 KXP Plunger 2
NO. Description QTY.
7 ¼” x 3/4” Truss Head Bolt 4
8 ¼” - 20 Nylon Nut 4
9 ¼” Washer 4
10 5/16” Carriage Bolt 3
11 5/16” Washer 3
12 5/16” Nylon Nut 3
Dust Cover
Turn Knob
Mounting Base Plate
Spline
Gun Boot Bracket
KXP Plunger
Kolpin now offers many accessory options for Polaris ATV and UTV models. For a complete listing of these KXP
accessories and Kolpin’s KXP Plungers that are compatible with Polaris® Lock & Ride® System, be sure to check
out www.kolpin.com , as new items will be coming soon.