Kolpin 20351 - KXP UTV Boottector Bracket User Manual
Kolpin Hardware
Rev. 1
Kolpin Outdoors, Inc., 205 N. Depot Street, Fox Lake, WI Phone #: (877) 9KOLPIN or (920) 928-3118
www.kolpin.com
20351 - KXP UTV Boottector Bracket
20351 Assembly -
1. Attach the Boottector Plate to the Base Plate using the (4) - 5/16" Carriage bolts, (4) flat washers and (4) 5/16”
Nylon nuts. Tighten loosely until final positioning is completed when the bracket is on the machine.
2. Next, insert the Spline through the Gun Boot Bracket as shown above in the illustration.
3. Place the Dust Cover on the back side of the Spline. Attach the Boottector Bracket to the Spline and the Dust Cover
using (4) ¼” x 3/4” Truss Head Bolts, and (4) ¼” Nylon Nuts, with the Nylock Nuts on the back side of the Dust
Cover. Do not fully tighten, as the spline is adjustable in the slotted bracket for fine-tuning the angle of the Gun
Boot to your ATV.
4. Attach the (1) – KXP PLUNGER to the base plate. Align the bracket on the UTV Bed Rail so the plunger lines up with
the existing mount location of your choice. Simply place the threads of the plunger through the hole on the Base
Plate and thread on the KXP Handle. This bracket is designed to work on either the left or right side of the vehicle.
5. Make sure the bracket is flat on the bed rail and tighten the KXP plunger securely.
6. Attach the Boottector Housing on the spline at the desired angle. Insert the Gun Boot for a test fit, and at this
point, you can make small adjustments by rotating the Boottector and letting the mounted spline assembly move
slightly in the slots. When you get to the desired location, take the Gun Boot and Housing off the spline and
securely tighten the (4) bolts holding the spline assembly to the bracket.
7. Secure the housing to the bracket with the turn knob. Insert “barrel end” of the Gun Boot through the Boottector
Housing and insert the Locking Pins through the holes in Housing making sure to capture the hole and the slots in
the Gun Boot. Adjust the bracket for distance and angle, and then tighten securely with the turn Knob.
CAUTION: Always make sure gun is unloaded before placing it in your Gun Boot!
NO.
Description
QTY.
1
Base Plate
1
2
Boottector Plate
1
3
Boottector Housing
1
4
Turn Knob
1
5
Spline
1
6
Dust Cover
1
7
KXP UTV Plunger
1
8
¼” – 20 x 3/4” Truss Head Bolt
4
9
¼” – 20 Nylon Nut
4
10
¼” Washer
4
11
5/16” Carriage Bolt
4
12
5/16” Washer
4
13
5/16” Nylon Nut
4
14
5/16” x 3” Lock Pin
2
Base Plate
KXP Plunger
Spline
Boottector Plate
Turn Knob
Housing
Dust Cover
Kolpin now offers many accessory options for
Polaris ATV and UTV models. For a complete
listing of these KXP accessories and Kolpin’s
KXP Plungers that are compatible with Polaris®
Lock & Ride® System, be sure to check out
as new items will be coming
soon.