INTELLINET NETWORK NSC15-WG User Manual User Manual
Page 85
- 85 -
FTP server name: Enter the address of your FTP server here. Valid entries are
either the IP address of the server (format:
111.222.333.444), or the domain name of the server
(format: domainname.com). Invalid entries are
ftp.domainname.com or http://domainname.com.
User name:
Key in a valid FTP user name here. Make sure that the user
account you wish to use has read and write privileges on
the FTP server.
Password:
The password for the FTP user account goes here. Repeat
the password in the field below.
Passive mode:
There are two types of FTP connections: Active and passive.
While the most common method is passive FTP, your server
may be set up to only accept FTP connections that utilize
active FTP. The correct value here depends on the FTP
server setup. When in doubt, we recommend using passive
mode, trying active mode only if you experience problems
connecting to the FTP server.
Attached file type: Select Snapshot if you want the camera to upload single
images (JPEG format). Selecting Video clip instructs the
camera to upload short video clips in length of max. 5
seconds. This option is only available in certain models.
Click OK to save the settings. When done, click on Test to verify the FTP
settings. A popup window will open that informs you whether or not the test
was successful.
The FTP settings are correct and the test has succeeded.