INSTEON Load Controller 220V / 240V 30 Amp, N/O and N/C (2477SA1, 2477SA2) Manual - Manual (Page 5)

240V Load Controller Owner’s Manual
Page 5 of 14
INSTALLATION
Tools You Will Need
•
Screwdriver (to remove the cover of the junction box)
•
Wire cutter/stripper
•
Various tools to wall-mount 240V Load Controller
Preparing to Install 240V Load Controller
CAUTION
Read and understand these instructions before installing and retain them for future reference.
240V Load Controller is intended for installation in accordance with the National Electric Code and local regulations in
the United States or the Canadian Electrical Code and local regulations in Canada. Use indoors only. 240V Load
Controller is not designed nor approved for use on power lines other than 120V 60Hz, single phase. Attempting to
use 240V Load Controller on non-approved power lines may have hazardous consequences.
Prior to installing 240V Load Controller, please review the entire installation procedure and take the following
precautions:
•
Because 240V Load Controller involves high voltage levels, it is recommended that installation be performed
only by a qualified electrician or by a homeowner who is extremely knowledgeable and familiar with
electrical circuitry. Please take an extra level of precaution when installing this device. If you have any
questions regarding installation, please consult an electrician.
•
240V Load Controller must be connected to a 2-pole tandem circuit breaker, rated for no more than 30
Amps. 240V Load Controller does not have over-current protection and therefore must be connected
through a circuit breaker.
•
Be sure that you have turned off the circuit breaker or removed the fuse for the circuit you are installing
240V Load Controller in. Installing 240V Load Controller with the power on will expose you to dangerous
voltages.
•
Connect only copper or copper-clad wire to 240V Load Controller
•
240V Load Controller may feel warm during operation. The amount of heat generated is within approved
limits and poses no hazards. To minimize heat buildup, ensure that the area surrounding the rear of 240V
Load Controller has adequate ventilation by clearing away excess insulation.
•
Don’t use 240V Load Controller to control devices that preserve, maintain, or contribute to human or animal
safety or life support
•
Don’t bury 240V Load Controller or any electrical cable or components connected to it. A buried power cord
may result in electrocution if improper cables are used or if digging occurs over the cable.
•
Don’t allow vegetation to grow on or around 240V Load Controller
•
Don’t install 240V Load Controller in a manner that allows water to accumulate around the unit
•
Don’t attempt to open 240V Load Controller. The 240V Load Controller case is sealed and can’t be opened.
There are no user-serviceable parts inside.
• Each 240V Load Controller is assigned a unique INSTEON I.D., which is printed on the device’s label. It is
recommended that you prepare a list of all the devices you are installing, including their INSTEON I.D. and
their location (e.g., 01.F7.G5, Mike’s bedroom light). It is only necessary to know the INSTEON I.D.s if you
will be using optional automation software (such as Smarthome’s HouseLinc) to program and control your
devices. However, it will be helpful to have a list of your devices, should you choose to use automation
software later. Creating a list prior to installation will prevent you from needing to re-open all the junction
boxes and fixtures to determine the INSTEON I.D.s.
IMPORTANT!
If you are not knowledgeable about and comfortable with electrical circuitry, you should have a qualified electrician
install 240V Load Controller for you. If you have any questions, please consult an electrician or call:
INSTEON Support Line
800-762-7845