INSTEON Dimmer Module - 2632-422 (France), 2632-432 (Germany), 2632-442 (UK), 2632-522 (AUS/NZ) Manual - Manual (Page 5)

Page 5 of 16 2632-422/2632-432/2632-442/2632-522 - Rev: 1/21/2014 7:46 AM
Note: If your local on-level is set to a brightness level that is less than 100%, the ramp rate will be faster than
programmed. For example, if your light has a 50% local on-level and a ramp rate of 2 seconds, it will take 1 second
for it to ramp from full-off to the local on-level.
1) Press and hold Dimmer Module set button until it beeps
LED will start blinking green
2) Press and hold Dimmer Module set button until it beeps a second time
LED will start blinking red
3) Press and hold Dimmer Module set button until it beeps a third time
LED will start blinking green
4) Press and hold Dimmer Module set button until it beeps a fourth time
LED will start blinking red
5) Slowly tap set button 2 times
LED will continue blinking red
6) Press and hold Dimmer Module set button to see the next available ramp rate
Load will ramp from off to on at the next available ramp rate
LED will continue blinking red
7) If this is the desired ramp rate, tap Dimmer Module set button to accept
Dimmer Module will double-beep and the LED will stop blinking
8) To see the next ramp rate, press and hold Dimmer Module set button again
Load will ramp from off to on at the next available ramp rate
Ramp Rate Presets
“Instant”
0.5 seconds
(factory default)
2 seconds
5 seconds
9) Test by turning off and then back on via the local switch
Light will ramp off and back on at the new local ramp rate
Resume Dim
When resume dim is enabled, each time you turn on Dimmer Module it will go to the previously used dim level. By
default, Dimmer Module will come on at 100% brightness, but to change the desired level, simply follow the
instructions below. The next time you turn Dimmer Module off and on again, it will return to the last used dim level.
1) Press and hold Dimmer Module set button until it beeps
LED will start blinking green
2) Press and hold Dimmer Module set button until it beeps a second time
LED will start blinking red
3) Press and hold Dimmer Module set button until it beeps a third time
LED will start blinking green
4) Press and hold Dimmer Module set button until it beeps a fourth time
LED will start blinking red
5) Slowly tap Dimmer Module set button three times
LED will start double-blinking red
6) Press and hold Dimmer Module set button until it double-beeps
LED will stop blinking