INSTEON Dimmer Module - 2632-422 (France), 2632-432 (Germany), 2632-442 (UK), 2632-522 (AUS/NZ) Manual - Manual (Page 10)

Page 10 of 16 2632-422/2632-432/2632-442/2632-522 - Rev: 1/21/2014 7:46 AM
6) After beep stops, release Dimmer Module set button
After a few seconds, Dimmer Module will double-beep
X10 Setup
Dimmer Module ships with no X10 address assigned.
Add X10 Address
1) Press and hold set button until it beeps
LED will start blinking green
2) Send the X10 address 3 times (with or without commands)
Example: A1-AON-A1-AON-A1-AON or A1-A1-A1-AON
Dimmer Module will double-beep and LED will stop blinking
3) Test by sending X10 on and off commands
Lamp will turn on and off
Remove X10 Address
1) Press and hold set button until it beeps
LED will start blinking green
2) Press and hold set button until it beeps a second time
LED will start blinking red
3) Send the X10 address 3 times (with or without commands)
Example: A1-OFF-A1-OFF-A1-OFF or A1-A1-A1-AOFF
Dimmer Module will double-beep and LED will stop blinking
4) Test by sending X10 on and off commands
Dimmer Module will not respond
Specifications
General
Product name Dimmer Module
Brand/manufacturer INSTEON
Manufacturer product number
France 2632-422
Germany 2632-432
UK 2632-442
Chile 2632-452
AUS/NZ 2632-522
UPC
France 813922012613
Germany 813922012620
UK 813922012637
Chile 813922014105
AUS/NZ 813922012644
Warranty 2 years, limited
INSTEON
INSTEON powerline mesh repeater Yes