INSTEON Dimmer Module - 2632-422 (France), 2632-432 (Germany), 2632-442 (UK), 2632-522 (AUS/NZ) Manual - Manual (Page 11)

Page 11 of 16 2632-422/2632-432/2632-442/2632-522 - Rev: 1/21/2014 7:46 AM
INSTEON RF mesh repeater Yes
INSTEON controller Yes
INSTEON responder Yes
Maximum links/scenes 400
Load brightness levels 32 when controlled locally (256 remotely)
LED
Green when load is on, red when load is off
Blinks green once when all responders acknowledge (can be
disabled via software)
Blinks red once if responder does not acknowledge
Blinks red or green during setup
Blinks red to indicate traffic (must be enabled via software)
Beep on button press Beeps when button is pressed (must be enabled via software)
LED brightness Adjustable, from off to bright
Local on-level Adjustable, 32 fixed brightness levels or resume dim
Local ramp-rate
Adjustable from 0.1 seconds to 5 seconds locally
(0.1 seconds to 8 minutes via software)
Local control Yes
Commands supported as controller
On Off
Fast-on Fast-off
Begin brighten Begin dim
End brighten End dim
Commands supported as responder
On Off
Fast-on Fast-off
Begin brighten Begin dim
End brighten End dim
Incremental brighten Incremental dim
Beep
Software configurable Yes
RF range Up to 50 meters (150 feet) open air
Phase bridge detect beacon Yes
INSTEON device category
0x01 dimmable lighting control
INSTEON device subcategory
2632-422 (France, 869.85 MHz) 0x0B
2632-432 (Germany, 869.85 MHz) 0x0F
2632-442 (UK, 869.85 MHz) 0x11
2632-452 (Chile, 915.0 MHz) 0x50
2632-522 (Aus/NZ, 921.0 MHz) 0x12
X10
X10 address 1 optional (comes unassigned)
X10 transmitter Yes
X10 receiver Yes
X10 status response Supported