INSTEON SwitchLinc Relay (Dual-Band) (2477S) Manual - Manual (Page 13)

Page 13 of 18 2477S - Rev: 1/21/2014 7:27 AM
1) Tap Set button 4 times quickly.
SwitchLinc will start beeping once per second.
LED will turn
green .
2) Check the LED behavior of other dual-band devices.
a. If the other dual-band device is blinking green , it is on the other phase.
Device connects the phases to SwitchLinc.
b. If the other dual-band device is blinking red , it is on the same phase.
Device does not connect the phases to SwitchLinc.
Relocate device if necessary (and where practical).
c. If the “other” dual-band device is not blinking
Device is not within RF range of SwitchLinc.
Device does not connect the phases to SwitchLinc.
Relocate device if necessary (and where practical).
3) Press Set button once.
SwitchLinc will stop beeping.
SwitchLinc LED will turn white.
Other device LEDs will stop blinking.
X10 Setup
Note: SwitchLinc ships with no X10 address assigned. To assign an X10 address, you will need an X10
controller to transmit it.
Adding X10 Address
1) Press and hold SwitchLinc Set button until beep.
LED starts blinking green .
2) From your X10 controller, send the X10 address 3 times (with or without commands).
SwitchLinc will double-beep and LED stops blinking.
3) Test by sending X10 on and off commands.
The light/load connected to SwitchLinc will turn on and off.
Removing X10 Address
1) Press and hold SwitchLinc Set button until beep.
LED starts blinking green .
2) Press and hold Set button until beep.
LED starts blinking red .
3) From your X10 controller, send the any X10 address 3 times (with or without commands).
SwitchLinc will double-beep and LED stops blinking.
4) Test by sending X10 on and off commands.
The light/load connected to SwitchLinc will not respond.
Other X10 Setup
For other X10 setup instructions, visit http://www.smarthome.com/insteon-x10-programming.html