Clear-Com HME DX200 - Manual (Page 7)

7
Headset Microphone Gain Adjustment
Some users speak louder or softer than others. The headset microphone gain adjustment helps to compensate for
these differences, raising or lowering the voice level of the user speaking into the microphone. Increase microphone
gain for softer voices, decrease for louder voices.
• To adjust microphone gain, first be sure the internal speaker is off.
• Press and hold the ISO button while pressing the VOLUME up ▲ or down ▼ arrow.
― When you reach maximum microphone gain, you will hear “Maximum.”
― When you reach minimum microphone gain, you will hear a double beep.
There are 16 steps between maximum and minimum microphone gain levels.
Headset Sidetone Adjustment
Sidetone is the level of your own voice that you hear in the headset earpiece as you speak into the microphone.
• To increase or decrease the sidetone level, first be sure the internal speaker is off.
• Press and hold the IC button while pressing the VOLUME up ▲ or down ▼ arrow.
― When you reach maximum sidetone level, you will hear “Maximum.”
― When you reach minimum sidetone level, you will hear a double beep.
There are 5 steps between maximum and minimum sidetone levels.
NOTE:
A trim pot is provided for fine tuning adjustments with a small screwdriver, through the hole labeled
SIDE TONE on the left side of the WS200.
Changing Batteries
When batteries are becoming weak, you will hear “Change battery” from the speaker or headset. When this happens,
remove the battery sled from the WS200 and replace the six batteries in it with fresh AA batteries. Be sure battery
polarity is correct when replacing the batteries.
Rechargeable BAT850 Batteries
If you are using the optional HME BAT850 Rechargeable Battery, remove the battery from the WS200 and
replace it with a fully charged battery. Recharge the battery in the optional AC850 Battery Charger according to
the instructions received with the charger. Charging time is approximately 3 hours.
Auxiliary Speaker Connection
An 8 ohm auxiliary speaker can be connected to the right side of the WS200, using the enclosed
2-position connector plug. Adjustments affecting the WS200 speaker will also affect the parallel
auxiliary speaker.
AC850 Battery Charger