Clear-Com HME DX200 - Manual (Page 2)

2
Power Setup
AC Power Operation
If using the WS200 with AC power
⎯
• Plug the connector at the end of the power supply cord into the 12-14 VDC power connector on right side
of the unit. Turn the sleeve on the connector clockwise to secure it to the unit.
• Plug the large female connector at one end of the AC power cord into the power supply. Plug the other end
of the AC power cord into an electrical outlet.
Battery Operation
If using the WS200 with battery power
⎯
• Press down and pull out on the two battery cover
release latches and lift the cover to open the
battery compartment.
• Insert six AA batteries into the battery sled, in the
positions shown inside the sled, and install the sled in
the battery compartment.
NOTE:
An HME BAT850 Rechargeable
NiMH Battery can be used instead.
• Close the battery compartment by pressing
down on its cover next to both of the latches
at the same time until they snap in place.
Having a fully charged (or new) battery in its battery compartment when operating the WS200 with AC or
external DC power can prevent interruption of communication during a power outage. The WS200 will
automatically switch to battery power.
Battery
sled
Battery
compartment
Battery cover
release latches
Power supply cord AC power cord
Power supply
Battery sled
with batteries